Markets Served: Factory Automation, Food Processing & Packaging & Materials Handling
CA Totally Enclosed Air Clutch
- Totally enclosed housing
- Protection against outside contaminants
- Used in washdown applications
- C-Flange mounted
- A Piston will move to engage the clutch
- Used in non Cyclic applications
- Hardened steel spline connections
- High temperature sealing materials
CA-CC PNEUMATIC CLUTCHES
CA-CC Clutches use o-rings as dynamic seals. Therefore adequate lubrication must be provided in the air actuating circuit to ensure the 0-rings do not run dry.
MODEL CA AIR CLUTCH – assembled in a totally enclosed housing that incorporates the C-face design for flexibility in mounting. When air pressure between 20psi and 80psi is applied to the inlet port, a piston will move to engage the clutch. The model CA is used in non-cyclic applications when long periods of engagement is required.
| STANDARD ASSEMBLIES | 625CA-CC | 875CA-CC |
|---|---|---|
| A | 4.499 | 4.499 |
| B | 2 1/16 | 2 1/8 |
| C | 1/8 | 1/8 |
| D | 3 7/8 | 3 7/8 |
| E | 5/8 | 5/8 |
| F | 4.501 | 4.501 |
| G | 6 ½ | 6 ½ |
| H | 3/8-16 | 3/8-16 |
| J | 13/32 | 13/32 |
| I (inches) | 0.626 | 0.876 |
| O (inches) | 0.625 | 0.875 |
| B.C.D. | 5.875 | 5.875 |
| INPUT SHAFT OHL* | 0 | 0 |
| OUTPUT SHAFT OHL* | 0 | 0 |
| NEMA FRAMES | 48Y/56C | 143TC/145TC |
| MODEL | 625 & 875 AIR CLUTCH | |
|---|---|---|
| TORQUE** (IN-LB) | @ 80 PSI | MAXIMUM RPM ALL UNITS 1800 |
| STATIC | 375 | |
| DYNAMIC | 300 | |
| HEAT DISSIPATION | .09 HP | |
| HEAT CAPACITY | 20,000 FT-LB | |
| WK2 OF CYCLING PARTS | 1.1 IN2-LB | |
| REPAIR KIT | 2869K(A) |
*Based on 10,000 hours bearing life with load 1 inch from bearing face.
**The initial torque on some units may be up to 40% less than torque values shown until the friction lining is worn in.
Dimensions shown are for general information only.
Certified prints will be furnished upon request for design and installation purposes.